Post 1 made on Saturday December 13, 2003 at 11:29 |
Philip250 Lurking Member |
Joined: Posts: | December 2003 2 |
|
|
Hello,
I'm new to all this and have just purchased a RU950 (Euro version of TSU3000). Before setting up my device I downloaded some very good samples from this site. I have X-10 in my house and an RF remote for it. On some of the samples I downloaded I was able to do an 'All Lights On' and 'All Units Off' commands through the RF from the Pronto to my X-10 RF receiver.
(I was not aware it could do this as I thought I would have to purchase an IR to X-10 interface module.) My initial joy, has turned to disappointment as I have been unable to do any other commands e.g. A1 on etc. and can find no information on this.
Is this possible through RF? If so, how can I get the HEX codes into my configuration? (I assume certain HEX codes tell the pronto to send out RF signals rather than IR?)
Any help would be appreciated?
Thanks,
Philip
|
|
|