Hi,

I recently purchased the X10 three way switch kit for my living room. There is a switch on each side of the room with a white, black, red, and ground wire
going to each. I installed both the slave and master X10 swith to the appropriate wall, and ran into a problem. I can turn the lights on/off no problem with the IR 543 remote...but the problem is, the slave swith only will turn the lights off, it wont turn them on. The master works fine...it will turn them on or off as it should. Any help with this would be greatly appreciated.



This message was edited by marainwa on 02/13/04 15:16.