Your Universal Remote Control Center
RemoteCentral.com
Lighting & Home Control Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 6 made on Tuesday March 21, 2006 at 22:52
EddieA
Long Time Member
Joined:
Posts:
January 2006
13
Thanks for all the information.

I connected my floor lamp (150W incandescent bulb) to a LampLinc dimmer, leaving the lamp's built-in dimmer set fully on. It worked fine for a short while (minutes), but then the lamp brightness started fluctuating, down to off and back up to fully on. This behavior could be stopped by turning the lamp off and back on again. However, about 15 mn later, the lamp was dead (which was fixed by replacing the built-in dimmer). Is this expected or one of the exceptions to Larry's "usually there is no problem."

Thanks.

Eddie


Hosting Services by ipHouse