Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 3 made on Sunday July 25, 2021 at 05:39
edmund
Elite Member
Joined:
Posts:
April 2002
13,739
Until your question I had no idea it could be done, so I searched for those directions and posted it without knowing it would work or not. I first factory reset a mx-900, did the steps. The remote had Loader at the top and mx-900 at the bottom of the screen. A couple days ago I programmed just the devices no codes on the stand alone mx-900 editor, at the time it wouldn't work because all the mx-900 had been programmed with ccp. Anyways it downloaded the device names into the mx-900 via the stand alone editor without any trouble.

Last edited by edmund on July 25, 2021 21:20.


Hosting Services by ipHouse