Your Universal Remote Control Center
RemoteCentral.com
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 14 made on Saturday September 12, 2020 at 14:47
Ernie Gilman
Yes, That Ernie!
Joined:
Posts:
December 2001
29,824
Jeez, I didn't feel pulled on at all.

On September 12, 2020 at 14:36, Craig Aguiar-Winter said...
Thanks guys.

Ernie your description of how to find the lens position on the ceiling is pretty much exactly what I had planned.

Great minds think alike. Or, as MAD magazine once wrote, small minds run in the same gutter.

Heís using a motorized drop down screen in a bulkhead so at least I donít have to worry about the wall being plumb.

No, but you may have to worry about being parallel to a non-level ceiling.

I once did an installation where we had to run wire laterally along an indoor concrete-finished block wall. We used plastic ducting, ran it PERFECTLY level, then backed up and looked at it... only to find the ceiling was not level and it all looked wrong!
Iíll seek out the Optoma recommended mount. Actually I feel a little sheepish not seeing that in my own searching. Thank you.

Everything doesn't occur to everyone. Not every time, anyway.
A good answer is easier with a clear question giving the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. ďBernieĒ Shaw


Hosting Services by ipHouse