Your Universal Remote Control Center
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 4 made on Friday September 11, 2020 at 19:51
Brad Humphrey
Select Member
February 2004
On September 11, 2020 at 19:14, Craig Aguiar-Winter said...
I donít do a lot of projectors and up to now the ones that Iíve done all had horizontal lens shift.

With no lens shift; make sure when you find the center of the screen on the ceiling, that you align the center of the lens and not necessarily the center of the projector. If the lens in center mounted in the projector, then it is one & the same. But if it is offset.... I've seen installers make that mistake more than a few times.

Also make sure you get your drop calculated well, so the projector lens is vertically aligned also. If you can use a pole extension with a lot of very small incremental adjustments, that is ideal when dealing with projectors like that.

Product I like:

With this pole adjustment:

And a top plate, depending on your installation.

Last edited by Brad Humphrey on September 11, 2020 20:04.

Hosting Services by ipHouse