Post 1 made on Thursday April 16, 2020 at 23:37 |
db999md Junior Member |
Joined: Posts: | April 2020 10 |
|
|
I have an MX-980 and I use CCP to program.
I have a main MRX-1 basestation with the RF250 IR sensor and a secondary basestation MRF-260 that I use to control the projector rather than running a flasher over to the projector.
the AVR Arcam AVR390 and Tivo run off the MRX-1 and the Projector is Epson 5040ub on the MRF-260
So as you would expect I have the tivo, the arcam, and the projector as separate devices. Tivo and arcam specified as MRX-1 and projector as MRF-260 in the RF section of CCP.
Where I am running into an issue is when I try to make a macro to turn everything on or off. It does not seem like I can get a macro to execute commands to both base stations. When I make macros I am using alias to the projector off and alias to the receiver off button. Do I need to "jump" to the projector page first ?
thanks in advance for any help Dennis
|
|
|