I bought a new processor, and support sent me the codes supposedly in RC5 format. I was going to use irscrutinizer to convert them to hex to put into ccp, put i can’t decipher their table. I pasted their response below, if anyone has any suggestions



“
Here is the code list, be careful: this is not always a simple increment for the input button. I had to find empty RC5 code slots:

Address: 13h (group 19: Pre-Amp2)
button: code (standard RC5)
-------------------------------
Format left : 4Eh (linear function down) (new button)
Format right : 4Dh (linear function up) (new button)
1: 01h (1) => 1
2: 02h (2) => 2
3: 03h (3) => 3
4: 04h (4) => 4
5: 05h (5) => 5
6: 06h (6) => 6
7: 07h (7) => 7
8: 08h (8) => 8
9: 09h (9) => 9
10: 68h (10) => 104
11: 69h (11) => 105
12: 6Ah (12) => 106
13: 6Bh (13) => 107
14: 6Ch (14) => 108
15: 6Dh (15) => 109
16: 6Eh (16) => 110
17: 6Fh (17) => 111
18: 70h (18) => 112
19: 71h (19) => 113
20: 72h (20) => 114
21: 73h (21) => 115
22: 74h (22) => 116
23: 75h (23) => 117
24: 76h (24) => 118
25: 77h (25) => 119
26: 78h (26) => 120
27: 79h (27) => 121
28: 7Ah (28) => 122
29: 7Dh (29) => 125
30: 7Eh (30) => 126
Source left: 0Bh (Group2: page step-)
Source right: 0Ah (Group2: page step+)
OK: 3Fh (System Select) (button moved, was named SEL or ENTER. There are two of them sending the same code)
Optimizer Preset left: 21h (step/preset-)
Optimizer Preset right: 20h (step/preset+)
Menu: 52h (Menu On)
Up: 50h (cursor step up)
Menu-Down: 51h (cursor step down)
Menu-Left: 55h (cursor step left)
Menu-Right: 56h (cursor step right)
Menu-Back: 57h (Menu Function)
Menu-OK: 3Fh (system select)
Vol+: 10h (Vol+)
Vol-: 11h (Vol-)
Bypass: 0Eh (personal pref.) (button moved)
Mute: 0Dh (mute/demute) (button moved)
Info: 54h (display A/V status) (button moved)
Light: 0Fh (display) (button moved)
DIM : 61H (“Solarization”) (new button)”