Your Universal Remote Control Center
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 30 made on Thursday February 20, 2020 at 02:50
Ernie Gilman
Yes, That Ernie!
December 2001
On February 20, 2020 at 00:01, jhakam said...
I hope this works. I am having problem getting the image to show up. I have used the 350 with my MX880 without issue. Only the 890 is giving me fits. The problem is not obvious.


How are you creating the image address? I've opened it up and extracted the URL that's inside it and the site says there's no such page.

Since it hasn't shown up with the method you're using, how about NOT trying to make it show up, but instead giving us the URL of where the image is? Although I don't know what the "blob" part of it is....
A good answer is easier with a clear question giving the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw

Hosting Services by ipHouse