Your Universal Remote Control Center
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 25 made on Wednesday February 19, 2020 at 20:49
Ernie Gilman
Yes, That Ernie!
December 2001
On February 19, 2020 at 19:48, jhakam said...
Right MRF350. My mistake. The answer is I have tried both. But it does not explain why everything worked before the MRF350. In fact if I remove the emitter from my TV it works just fine.

That tells me that, in the RF control section of the programming, the TV commands are set to IR, so the commands come out of the remote as IR. I don't know why the TV would not see those commands if "the emitter from my TV" is connected, unless you're not actually using an emitter on your TV but instead are using a cable from the output of the MRF350 to an emitter input (or IR input).

Check your programming to be sure the RF setting is right for the TV commands. Maybe also provide a bit more detail as to how the TV emitter is connected and placed.
A good answer is easier with a clear question giving the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw

Hosting Services by ipHouse