Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 3 made on Thursday January 2, 2020 at 15:25
Leej
Junior Member
Joined:
Posts:
January 2020
3
I know this is an old thread, and the MX-810 is an old remote.

However, I have several of them and like them. Recently, I have had trouble sending software to the remote. I am able to run the software, but when I send software to the remote, it gets about 2/3 of the way done (typically about 82%, but not always the same), and then says
"Disconnected, please try again [EC2]".
At that point I have to remove the battery from the remote, and then try again.

If I keep trying, eventually I can usually get it to complete, but it takes like 10 times or more.

I have tried different USB cables, different USB ports, different remotes, with the battery charger plugged in and not plugged in, etc. but I keep having this problem.

I am running Windows 10, and I have been able to successfully load software to the remote in the past, it just takes more than 10 tries...

Does anyone have any info on how to resolve this? Thanks.

Lee


Hosting Services by ipHouse