Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 10 made on Wednesday April 17, 2019 at 14:13
Duct Tape
Loyal Member
November 2008
On April 17, 2019 at 10:58, wessleym said...
punter16, I tried what you suggested.
1. I saw no difference in performance after moving to several different locations, far away from other equipment.
2. We use an MX-980 for a different television in the house. I copied the file for the broken MX-980 to this remote. Then, on the new MX-990, I made a simple file with only working volume up, volume down, and mute buttons. I set both of them to the same RF ID. The MX-980 operated the equipment perfectly. The MX-990 continued to have the same issues.

Duct Tape, here's a link to the file I made for the #2 test above.

Because the MX-980 works so well and the MX-990 does not, I'm starting to wonder if it's a problem with the MX-990 in general or with this particular MX-990.

The only thing I notice that I'd try, (though it really shouldn't matter) is to assign the IR data to a specific emitter port in the RF control tab.

and here's a dumb question.  The MX990 wouldn't happen to have an "i" at the end of the model number, would it?

Hosting Services by ipHouse