Post 1 made on Monday February 11, 2019 at 23:13 |
joltman Long Time Member |
Joined: Posts: | February 2019 17 |
|
|
I purchased an MX-990 from Surf Control and a used MSC-400. I purchased the cables, adapters and TRRS jacks to construct my serial cables. The MSC manual says :
Tip: NC Ring: Transmit Ring: Receive Sleeve: GND
I thought I'd read something on this forum about wiring the RX ring to TX serial pin. That's how I've made other serial cables in the past. However my test in CCP isn't working. Should I wire the RX ring to the RX pin on the DB9 adapter? The manual doesn't say much about it. Thanks!!
|
|
|