Your Universal Remote Control Center
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 12 made on Sunday November 25, 2018 at 08:04
Ernie Gilman
Yes, That Ernie!
December 2001
Thanks, David.
A crucial point is that the Lutron note you linked to talks about a Lutron In-wall Sensor, while we're talking about an Occupancy Sensor Switch, that is, the sensor is buried inside the switch enclosure, with no access to the actual sensor wiring. As you saw, that means is no possibility of putting the SENSORS in parallel.

People normally don't put lighting and outlets on the same breaker, but I bet there will be complaints, and I can even see this product being recalled, if anyone ever installs a MS-OPS2H on a circuit protected by a GFCI. It should instantly pop a GFCI.

Or am I wrong and lighting circuits must be separate from outlet circuits?
A good answer is easier with a clear question giving the make and model of everything.
"The biggest problem in communication is the illusion that it has taken place." -- G. “Bernie” Shaw

Hosting Services by ipHouse