Installing my own security system. Not really an expert at security.
I did not run for wire jumpers from one smoke detector to the next. I just homeran a 4 cond wire from each smoke back to the panel
I'm running short on zones so I want to combine all 5 smokes onto 1 zone. By combining all 12v+ and grounds together and then all supervised wires together to lay down on one of the zone terminals.
Here's what I know so far:
the smokes are a normal open circuit, that short when faulted (unlike glass breaks or motion sensors, which are normally closed)
I will need to put an EOL resistor across the terminals of the zone
This zone will need to be programmed as a smoke so it behaves accordingly
It will not be entirely supervised since the smokes don't feed each other, rather all common together back at the panel. But the system should still go into alarm when/if any of them detect smoke
This is a GE NX8E panel
The panel also has a + terminal to provide power to the smokes. Presumably to be able to reset (power cycle) the detectors when needed?
Bosch DS 285 smokes with DS292 mounting bases
More as the thread moves along
Thanks in advance
Chasing Ernie's post count, one useless post at a time.