Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto NG Family Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 4 made on Tuesday February 13, 2018 at 22:05
Lyndel McGee
RC Moderator
Joined:
Posts:
August 2001
12,992
You may have a ground or voltage loop. This is especially common when you are connecting equipment directly with mono plugs and not using stick on emitters. For example, some comcast cable boxes require a 3 pin stereo plug which is intended to be connected to an IR receiver such as a xantech one which requires +12V.

I would start by disconnecting any equipment that is direct coupled (not using emitters) and see where your problem might be.

Best of luck.
Lyndel McGee
Philips Pronto Addict/Beta Tester


Hosting Services by ipHouse