Your Universal Remote Control Center
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 11 made on Friday February 9, 2018 at 13:49
Senior Member
April 2009
On February 9, 2018 at 09:26, SWFLMike said...
crosen - it sounds like you're looking to drop the projector and screen by the same amount, and I *highly* doubt that's what you actually want/need to do. I would think (based on past experiences) that you'd first set your screen limits to drop that to the desired height, then you'd drop the projector to the point where the top of the screen is at the same height as the top of the lens when the projector is level. That amount would likely end up being way less than 60".

The 60 drop is from ceiling to top of the screen. That distance is large because the ceilings are 12 high.
If it's not simple, it's not sufficiently advanced.

Hosting Services by ipHouse