UGG ! I have been watching the videos and “practicing” with mock systems. I finally committed and did a simple one room APEX yesterday. I preprogrammed off site as much as I could, added driver and network settings on site. T2X, XP6, ZM24. It went well until I couldn’t get the projector to turn on or off. It would work IR, but not thru the XP6 and the Balun.

I figured I would simply go stand alone for those commands only, until I could figure out the issue. For the life of me I couldn’t figure out how to send IR from the remote! Wasted a couple hours and almost jumped ship back to ID.

It forced me to figure out the issue sooner than later! Turned out to be the balun (Clare Controls ) was putting stray voltage on the emitter

Overall I think APEX will be good for me as graphics and variables are not my strong suit.