On November 22, 2017 at 17:40, goldenzrule said...
Thanks for sending the file Todd. I replied here rather than email just to get others thoughts. One thing I noticed is the Fios is on port 2 in all 3 bases. If I have multiple bases in a house, I typically will place them on different ports on each base. It shouldn't be necessary, but I recall way back being told this is best practice. I don't recall if it was in training or just something I heard along the way. It's one thing to try at least. I would probably change the RFID from the 0(letter) ID to just a number on the MRX2 just to see if it helps as well.
So its been a little while before customer was avail and stopped by today. Turns out the issue was the MRF350 in the family room had the RF light stuck on. It wasn't an interference issue. Was just locked up. Thus, it grabbed all RF commands and sent them to all ports.
After solving that. I moved the antenna further away for extra precaution. I also made sure I put the same components in the rooms on different ports on their prospective base stations. Changed the base stations ID's, etc to prevent further issues, unless it locks up again.
I now have a new question. Just found out customer has the iPhone app for use with his MRX2 and unlike TC its totally independent programming. I did pull it off his iphone into CC. But, I have learned commands for the Lens Memory positions set on his Epson projector on the MX980. Is there any way to copy these learned commands to the iPhone? I don't have the URC IR reader to learn them again. I now have to reprogram a bunch of macros I created today ion the MX980 now to the iPhone app.
