Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto NG Family Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 8 made on Monday November 13, 2017 at 02:21
PCWorth
Junior Member
Joined:
Posts:
October 2017
5
Some good news! I have finally managed to load the appropriate drivers for ProntoEditNG on the old laptop running WXP,and successfully uploaded the configuration from my Pronto.
I have been examining the various aspects of the existing config, using the programme manual, but I can’t glean enough information to even work out the first step of allocating IR codes to the device I wish to add!
Basically, my Pronto talks to an HDMI switcher which decides which device is in use. I first need to work out how to tell the Pronto to talk to the currently vacant position on the HDMI switcher, into which my new device will be plugged. The output of the selected “channel” of the switcher then goes to the plasma screen receiver.
Does anyone know of a post or other reference that explains how to work through these processes, one step at a time?
Any further advice or suggestions would be welcomed!
Peter
Peter


Hosting Services by ipHouse