On November 7, 2017 at 13:26, imt said...
The wire mapped out all OK? No shorts? I would think if degraded by water or even a lightning strike wouldn't there be a short in the cable?
You mention its approx a 100' run but the tester is showing 215'. This is making me think short if it truly is closer to a 100' run.
Are you sure you are reading that speed test right. Why would 10G be cat3 speed? Unless its 10mbps and not 10G.
You are right, I just looked over the test again and it is slightly over 10mb/s which is likely too low a data rate for an extender.
This is what I am supposing anyway. It appears that most folks just use it for checking runs after a prewire, and maybe it has not gotten a lot of use as a troubleshooting tool in this type of situation (HDbaseT).
Thank you for your input.