On October 14, 2017 at 17:54, buzz said...
When using the tool, there is no need to back out because the guillotine cutter always trims flush. All of the slack can be removed before crimping. It's also easy to check the wire colors before trim.
It looks like you didn't read the entire thread, but jumped in somewhere:
On October 13, 2017 at 16:21, flandon said...
Simply Condition you wires in the correct (B only) pin out. Clip them long with your dykes.
Slide through the EZ Past the point where you want. Clip the wires 1/8" or less evenly in front of the connector.
Ever so Gently Pull the whole wire back so the little wires are just inside of the connectors.
Crimp end on without moving wire in relation to Connector.
On October 14, 2017 at 04:18, Ernie Gilman said...
But this means the connector's strain relief isn't engaged.