On October 13, 2017 at 16:21, flandon said...
I Like the EZ ends for Cat6. But don't buy one of these. more trouble than there worth.
Simply Condition you wires in the correct (B only) pin out. Clip them long with your dykes.
Slide through the EZ Past the point where you want. Clip the wires 1/8" or less evenly in front of the connector.
Ever so Gently Pull the whole wire back so the little wires are just inside of the connectors.
Crimp end on without moving wire in relation to Connector.
This eliminates the Problem with the EZ's. The wires don't stick out so they fit into all Jacks.
The wires don't stick out so they don't short.
Or just go with the redesigned EZ's and tool which corrected many of the short comings on both items.