Hello all. I am trying to gain control of a tv lift that is not very accessible. The emitter is already in place and I am able to tie onto the cat 5 with an emitter head to verify I am sending codes to the general location. What I was given from previous installer was his "learned " codes for raise, lower and stop. I took the hex given to me and tried to put it into the RTI infrared library but I keep getting error unknown code type. Ive tried to break it up into sections of 4 but then I get invalid zero-length time detected. These supposedly came from a savant system. Anyone have any suggestions ?

000000000000A02800B8001A00B8001A00B8001A00B8001A00B8001A001B00B900B8001A001B00B900B8001A001B00B9001B00B9001B00B9001B00B9001B00B9001B00B9001B00B900B8001A001A033A00000000
up
000000000000A02800B8001A00B8001A00B8001A00B8001A00B8001A001B00B900B8001A001B00B900B8001A001B00B9001B00B9001B00B9001B00B9001B00B9001B00B9001B00B900B8001A001A033A00000000
down
0000000000009753000F0019000F003D000F0019000F003D000F0019000F003D000F0019000F0019000F003D000F0019000F0C01000F0019000F003D000F0019000F003D000F0019000F003D000F0019000F0019000F003D000F0019000F0C0100000000
stop