I am a relatively new Crestron programmer and I am making a silly mistake that I am hoping you can spot.
This is on a DINAP3, programmed with D3Pro. Program 01 has a virtual keypad, tied to IP-ID 6. It is exported via RSD from the D3Pro lighting program. It is up and running. This is the only IP-ID on the Program 1 IP table.
Program 02 is a SIMPL program with only two devices configured. One device is the same virtual keypad, which was added to the SIMPL program via importing the RSD. The second device is the Crestron App, on IP-ID 7. There is a basic interface on the ipad, made with VTPro-e, that seems to be working fine.
When program 02 is loaded, the Toolbox error log says that IP-ID 6 is already in use. What I can't figure out is why this is an error, or more important, how to fix it. it. How can you ever export a device without ending up with an IP ID conflict if it shows up in the original program and in the exported program.467. Info: LogicEngine.exe [App 2] # 2017-06-18 21:23:54 # Loading program from \SIMPL\app02
468. Info: LogicEngine.exe [App 2] # 2017-06-18 21:23:54 # Loading Program \SIMPL\app02\app_process_1_1.bin.
469. Error: LogicEngine.exe [App 2] # 2017-06-18 21:23:54 # Exclusive device Slot-02.IP-ID-06 is in use by Program 01
470. Notice: LogicEngine.exe # 2017-06-18 21:23:56 # **Program 2 Started**
471. Info: LogicEngine.exe [App 2] # 2017-06-18 21:23:56 # Going to steady state now
Last edited by AvidScramber on June 20, 2017 00:03.