I am using the RTI Lutron Driver with Switch Commands to Toggle the lights on and off. I have not been able to figure out how to get the Raise or Lower last button pressed to work correctly with the driver.

On the Lutron RA2 I have Phantom Button 1 set to Raise last button pressed and Phantom Button 2 to Lower last button pressed.

When I try using the PB 1 through the RTI Driver it will Raise the light level but will not stop until it is fully on.

Is there another way to do what I am trying to do?

I simply have a page of all the lights in the house. From this page I wan't to toggle them off and on and see the status which I can currently do. Then I would like to be able raise or lower the last button pressed but not sure how to get this to work correctly.