Post 1 made on Friday February 26, 2016 at 09:33 |
Amherst Lurking Member |
Joined: Posts: | February 2016 5 |
|
|
Hello everyone...new to the forum and a more than decade long lurker here. Have gleaned a ton of knowledge from this site over the years and would like to say thank you to all the contributors here for that.
I have just started a new (to me) foray into the world of the PEP configuration software after obtaining a practically new TSU9600. Have been using a pair of TSU9200's for years and they have served me extremely well. I so far have found PEP quite daunting, especially the scripting part and am in the process of my first build.
The big question for here is the documentation for PEP states that it will accept a CCF file for a piece of equipment and convert it to Hex natively. Has this been eliminated in the PEP 3.0 build, (can't find it)? Is it available in the earlier 2.0 builds?
Thanks, Stu
|
|
|