Post 7 made on Sunday January 10, 2016 at 16:51 |
EllisGJ Long Time Member |
Joined: Posts: | January 2016 19 |
|
|
Peter, thanks very much. Thanks to your tips, I discovered that WPA instead of WPA2 was selected in device properties. However, after correcting this, making sure that the SSID and passphrase were correct and using Fing, the T2X still doesn't connect. In the control panel on the remote, I see mode = DHCP; DNS is set to the correct IP and the SSID is correct. However, the unit's IP address and mask are both 0.0.0.0.
Greatly appreciate any further ideas you might share.
|
|
Gary |
|