Your Universal Remote Control Center
RemoteCentral.com
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 25 made on Wednesday June 24, 2015 at 08:39
highfigh
Loyal Member
Joined:
Posts:
September 2004
8,311
On May 17, 2015 at 19:39, Fins said...
My problem with tapcons isn't the strength. It's that I've never had great luck getting them to tighten and not strip out

Do you use their drill bit, or your own? I have a set of Bad Dog bits and the smaller TapCons don't work with the 3/16"" bit, but the 1/4" and 5/16" do. I gave up on the small TapCons because my Milwaukee hammer drill twists the heads off every time. If a stud sticking out isn't a problem, I sometimes use wedge anchors (NOT Acme-Johnson).
My mechanic told me, "I couldn't repair your brakes, so I made your horn louder."


Hosting Services by ipHouse