Post 1 made on Friday June 19, 2015 at 08:11 |
Hey All,
First post, most of my answers I can find in the forum (thanks). But I have the following issue and I'm wondering if it has been seen before and if there is a possible fix.
I have a Yamaha HTR-6190 that I'm trying to control with an MX-980. Within CCP I have the RXV1800 selected (as there is no HTR6190). In my living room I have a 5.1 speaker Setup.
When I use the MX980 to power up all my devices the Yamaha always turns on Zone 2 and Zone 3. This essentially disables my surround back speakers. The only way I can seem to turn off zone 2 and zone 3 by the hard buttons on front of receiver (huge pain cause its downstairs in a closet). I was hoping that I could just add some programming in the macro section to turn these 2 zones off but I haven't been successful.
Can anybody help me out?
Thanks in advance for reviewing my post!
|
|
|