Post 5 made on Saturday March 7, 2015 at 16:47 |
Jakeman, please don't take this the wrong way, just curious because I have just bought one of these myself--
Here are the steps on page 16.
Programming the Master Power Key 1. Press and hold the P key for 3 seconds until the LED indicator turns on and stays on. 2. Release the P key. 3. Press the device key you want to add to the power macro. 4. Press the CH + key and the LED blinks. 5. The LED stays on. 6. Follow steps 3 and 4 to add more devices to Master Power. 7. When all devices are added Press VOL + key to enable Master Power. 8. Press the P key to complete the process.
I am just curious, after you enter the first device and press the CH+ key, the LED blinks and stays on, correct? Then, when you press the next device key to add the second device and press the CH + key, the LED blinks again and then stays on, right? The LED stays on until you press VOL + then P, when it goes off.
Just checking for the proper feedback from the device during the programming process.
|
|
Bob Heck |
|