Post 5 made on Wednesday July 23, 2014 at 07:37 |
LivewireAndrew Lurking Member |
|
|
I know this is a bit of a bump, but I'm so close to figuring this out thanks to this thread!!
I just need to know how to make that delay between characters in control4 driver wizard!!
The documentation says about using # followed by the number of milliseconds, but this doesn't seem to work inside the "", as far as i can tell iv tried every combination of codes and # that i can think of, anyone got this working?
Thanks for anything you give me that might help!
Andrew
|
|
|