On June 6, 2014 at 01:36, JoeChan said...
Thank you! Are your codes come from sony protocol manual?
I found there are IR command codes in Sony protocol manual:
[Link: files.remotecentral.com]but I don't know how to converte them into hex code.
-------------------------------------------------------------Table 2-9 Infrared Remote Command Code For Setup
CATEGORY Code Name
15 bit 20 bit
PROJECTOR PROJECTOR-E
O _ 15 POWER ON/OFF *1
O _ 24 PICTURE MUTING
O _ 25 STATUS ON
O _ 26 STATUS OFF
O _ 29 MENU
O _ 2B INPUT A
O _ 2C COMPONENT
O _ 2E POWER ON *1
O _ 2F POWER OFF
O _ 33 CURSOR →
O _ 34 CURSOR ←
O _ 35 CURSOR ↑
O _ 36 CURSOR ↓
O _ 57 INPUT SELECT
O _ 5A ENTER
O _ 6F HDMI 1
O _ 70 HDMI 2
O _ 7B RESET
*1:
-------------------------------------------------
I planned on x-learning the codes from another db, but my USB ports have been down most of the week. I didn't know there was a protocol sheet. IRScrutinizer will generate the codes for you.
Based on my post
[Link: remotecentral.com] we know this projo uses or responds to the Sony15 Ir protocol. I'll have to fully Injest that protocol link when not on mobile and verify the ir scrutinizer generation from my xlearns.