On May 13, 2014 at 16:07, Duct Tape said...
you will just take apart the switch like you have done already, then solder onto the contacts where the up and down buttons are. use thin wire such as cat5 for this purpose. you will end up with 4 conductors which will get connected to relay 1 and relay 2 on the msc400.
cat5 wires are the network wires, right?
Mrx10 is not compatible with that remote.it only works with Urc Total Control products.You could also look into an IR controlled relay. That would be the most economical. Google: Pro Control Relay 4. It has an msrp of $160.I would link to it but my phone is being a pain.
But if I found a good used MSC400 with a good price...is the MSC400 a better device than Pro Control Relay 4 since it has more types of connections?
Is it worth the expense?
Anyway Pro Control Relay 4 could control lights on/off? Or the MSC400 is always the better choice?
Thanks for all your suggestions!!!