Was all of the following done?

SETUP OF CRESTRON
HARDWARE:
Baud Rate - 9600
Parity - Odd
Data Bits - 8
Stop Bits - 1
VENDOR FIRMWARE: For Advent:
Control Panel Version 1.6
Automation Module Version 3.43
For Concord:
Version 2.5 or later
VENDOR SETUP: You must use the GE Printer/Automation module to
enable communications with the Crestron system. This
module will attach to the GE bus, and will provide an
RS232 port for use by the Crestron system. When
ordering this module you must specify that it is for a
Crestron control system. Use the 9 pin connector.
The DIP switches inside the module should be set as
follows:
1 - On
2 - Off