you wont be able to see your crestron processor or any other panels for that matter while using toolbox, as they are on a different subnet from the rest of the network. When getting used hardware and setting it up for a system, the best thing to do FIRST, is to connect via serial or usb, etc (NOT NETWORK!) and configure the IP addresses of all devices accordingly. Once this is done, the IP table for corresponding devices may or may not have to be modified as well. As for the Android control, this will only work if you have the logic for a mobile app in the SIMPL programming. It is not exactly as simple as getting everything on the same network and having it all work. The control processor needs to be programmed accordingly as well, so that when the mobile app reaches out to the processor, the phone then can be directed to the touch panel file that it needs to look at.