the nevoconnect is not a network device, it plugs in via USB.
ihere are the steps for assigning a device to the nevoconnect
1. find the Nevo Ecosystem tab under the Hardware section and click on it 2. Expand the tree where it says NevoConnects. You should see a Mac address for each nevoconnect in your project. 3. double click on nevo connect that you want to edit. a window will pop up. 4. make sure that configure connections is checked, then click next 5. here you will see a list of all the devices in your project. all you do at this point, is click in the column where you have the IR emitter connected. 6. Click on Finish.
To update the firmware: 1. find the Nevo Ecosystem tab under the Hardware section and click on it 2. Expand the tree where it says NevoConnects. You should see a Mac address for each nevoconnect in your project. 3. highlight the nevoconnect that you want to update. 4. make sure that the nevoconnect is plugged into your computer via USB 5. click on the blue arrow that points up. 6. the rest of the process is pretty simple to figure out following the onscreen direction.