On July 5, 2012 at 15:28, urskog said...
I'm fiddling with the network settings here and simply can't get WPA to work.
My WAP is a Linksys WRT54GL with dd-wrt.
If i run it with no security or wep64/128 then the Pronto gets an IP-address just fine, but if I go back to WPA which I would prefer to run the Pronto never gets an IP, and it doesn't give an error message either in the diagnostic window.
I've tried both AES and TKIP with the same result.
The only thing I change between the settings is the encryption mode and the passkey, the rest is identical (DHCP, channel number, SSID etc).
Any ideas on what I could try to get the Pronto to accept WPA?
I have never used WPA with my Pronto remotes unfortunately. Don't even use PEP v2 which is required for WPA. Still using PEP v1 exclusively. That being said, I'd highly recommend going with a dual band router that allows for running both WEP128 and WPA concurrently. The post found
here details the router that I use. While your results may vary I've never encountered a single connection issue with my Pronto TSU9x00 remotes on WEP128.
