Post 15 made on Tuesday August 28, 2012 at 08:58 |
mdmm Lurking Member |
Joined: Posts: | August 2012 1 |
|
|
Request for Informations. I am in Mississauga,ON. Please clearify following items, 1- Coat hangers are made of iron/steel.Is it ok to use and yours iron made hangers arms are working good?? 2-What should be good length of each arm ?? and what must be distance between end point of each arms. 3- Should these arms be at the same line and level or I can make them up and down to avoid touching.What is best distance beween 4 points in line and between opposit points on wood. 4- If putting on roof,Can i wrap whole antenna or only arms in plastic tape to avoid rusting and water damage,. 5- What is best position to place. Vertically upward facing toward USA or horizontally lay down on roof . 6- If i put tin plate behind,should it be flat or make it a little concave to converge signals on rods?? Will appreciate your helping hints,please.
|
|
tiger |
|