Hello!

Sorry for the delay to answer. My job requires me to travel a lot.

I am using a software called BitWise Controls Project Editor, from BitWise Controls (www.bitwise.com).
It is a software to build interfaces to be used with iPad, iPhone or Android devices.
It has a built in feature that converts from Pronto Hex format to its own format.
It has also a hardware called BC4 that learns (not always) directly from RC devices.


In fact, I made a mistake in my last post. The code that I compared to the Pronto Hex one is in BitWise format.

Here is the correct comparison:

Ch+ in Pronto Hex Format:
0000 0073 0000 0021 0060 0020 0010 0010 0010 0010 0010 0020 0010 0020 0030 0020 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0020 0010 0010 0010 0010 0020 0010 0010 0010 0010 0010 0010 0010 0010 0010 0010 0020 0020 0010 0010 0020 0010 0010 0020 0010 0010 0010 0010 0010 0010 0020 0010 0010 0010 0010 0010 0010 0010 0010 09DD

Ch+ in BitWise Format, after converted from Pronto Hex above (Doesn`t work):
3501013100E607052C01B900DC00DC00DC01B9029601B901B900DC01B901B900DC881DA10112231111111412111115142111411160

Ch+ Learned directly from BitWise Controls BC4 Hardware (works):
4501014100DD0700DD87AE052E01BE029701BC01BA01BC01BA00DE00DD01BB00DD00DE32166552666666646566633645666466501665526666666465660E63364566646650

I think that are two possible problems:
1) Error in the conversion from Pronto Hex to BitWise;
2) The source code (RMDU file) is not compatible with my hardware (Sagem DSTIH78 and Sagem RSTIH89).

In the next weekend one friend of mine will bring a Pronto RC with all the codes above and we will see if it works.
If it doesn`t, probably the problem is in the source file (RMDU).

After the test I will share the results here.

Thanks for now.
Best regards,

Marcelo