Your Universal Remote Control Center
Original Equipment Remotes Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 6 made on Wednesday July 25, 2012 at 23:30
Select Member
August 2009
On July 25, 2012 at 06:50, kostaus said...
I found this: [Link:]

Would it be appropriate ?

Well, there are some uncertainties.  First, we don't know 100% which IR protocol your STB uses. I don't know for sure about the remote you linked, which has motion control built in, but its sibling remote can handle both 1.253 and 2.253.  It has the Cable 1631 and TV 1523 codes built in. If your STB uses 2.253, we'll need to use the 994 command (shown in the Extended Instructions) to manually assign the functions, since this setup code is intended for a TV instead of a STB. 
But assuming that your STB uses one of the two above IR protocols, we'll be able to make it work.

Your Onkyo Receiver can use any of Audio 1320, 1805, or 1993.

Hosting Services by ipHouse