Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 4 made on Saturday July 7, 2012 at 10:27
kgossen
Super Member
Joined:
Posts:
March 2008
3,026
I don't know of a way in CCP to sustain the signal for the time you need without holding the button for that time. You could try increasing repeats and see if that would work but the maximum repeat setting is 255 so don't know if that would be enough. I assume the 1200 has the "sending" indicator on the screen (usually upper right corner). Change the repeats to 255, send the command and see how long the indicator stays lit up. Divide that into the 2 seconds and repeat that many times one after the other, add your select, select and see if that works. 

CCP leaves a LOT to be desired when it comes to programming.

Last edited by kgossen on July 7, 2012 10:41.
"Quality isn't expensive, it's Priceless!"


Hosting Services by ipHouse