I am in need for some help trying to convert the following from RC5 to HEX. If anybody could help I would very much appreciate
Here is the list of remote commands for all the preamps and integrated amps. They use the RC5 protocol. The extra 5 commands at the bottom are on the "newer" revisions of all preamps except VK-3i/3iX/5i/5SE. You just have to try and see if they work. If not, the processor chip can be switched out.
The Display code works like this:
preamp onpreamp off ------------------- short presschange display brightnessturn preamp on long pressturn preamp offno action
A long press is defined as continuously sending the code (holding down the button) for approximately 1.5 sec.
The system code is preamp #1 = 16 (10 hex) Also available is preamp #2 = 19 (13 hex) requires processor change