Your Universal Remote Control Center
Philips Pronto NG Family Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 38 made on Tuesday May 1, 2012 at 13:25
Lurking Member
May 2012
Okay, I have tried every single thing that is posted on this site, in regards to new Motorola U-verse cable boxes. Nothing is working. The problem that I am having is that there is some inherrant delay in the code. When I push channel 127, I get 1 and then two seconds later 2 and then two seconds later 7. So it actually goes to channel 1 and then channel 2 and then channel 7. This delay is in all of the code. Has anyone run into this using RTI. I have an XP-8, 5 RK3V's, 3 PCM8's and 12 of these boxes to control. All other code fires off just fine. Thanks.

Hosting Services by ipHouse