Can anyone confirm if a RA2 dimmer switch will fit behind a blank wall plate if you remove the front cover, LED light pipe and that little clear plastic piece that makes contact with the switches down on the circuit board?
Doing a retrofit/remodel and have several banks of switches (4-7 gang) with no where to hide the switches. Crazy idea is to place the switches down low at outlet height with a blank cover over them painted to match the wall and then use a wall keypad for control.
Client and designer don't want to see the switches, but no closets or accessible attic or crawls space to hide them... this is the only thing I could come up with to minimize the visual impact.
Won't work unless I can strip off the front of the switches and get a blank to fit over the top. I was worried about the air-gap disconnect that swings out from the front of the switch disabling the switch if the cover is removed, but I'm pretty sure the switches still work with the cover off.