Post 1 made on Monday January 9, 2012 at 09:26 |
adk highlander Long Time Member |
Joined: Posts: | March 2010 65 |
|
|
I want to use one of the relays on the back of my MSC-400 to trigger on the amp that powers my bedroom speakers.
I have a mono trigger cable that has been cut to expose the red and white wires.
The ports on the back of the MSC are an unswitched 12 +/- power and the relay has Com (common), NO (normally open) and NC (normally closed).
I know that I will use the NO which I will issue a close command to complete the circuit to turn the amp on. I am just confused about the exact wiring.
Do I run my white wire from the trigger to the - of the 12v power then run red wire from trigger to NO of relay and a jumper wire from + of 12v power?
Thanks.
|
|
|