Your Universal Remote Control Center
Lighting & Home Control Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Thursday January 5, 2012 at 03:29
Long Time Member
December 2011

I purchased the Lutron Qrafik Eye QS along with the QSE-IO module.

I would like to control the shutters along with the projection screen in my living room using the QSE-IO, where I need to control them separately (Open, Close, Up, Down & stop) from the shade control in the Grafik Eye QS.

The problem is that I read the user manual along with technical specs and installation guide but none of them helped me how to do the wiring and the configuration (Dip switch and the programing).

My shutter is 220 volts AC with 0.5 Amps direct motor stops when you disconnect power.
And the screen is 12 volts DC over-ride 3 terminals (Up, Down and stop).

Kindly help me ASAP since Iím holding the room only for this function, and I already disconnected the power for that purpose.

Hosting Services by ipHouse