Your Universal Remote Control Center
iPhone & WM Remote Apps Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 3 made on Tuesday September 6, 2011 at 04:02
Lurking Member
February 2006
The code that iRedTouch stores is a little bit different from the one that was learned using the PC software.
Here's an example of a code learned with iRedTouch 1.6:

You were right to add the "1,1", but unfortunately this only works in the now current release 1.6. Please try again with the updated app.

FYI: in my example, the freuqency (40064) is followed by the "Repeat Count" (or "RC") "3". This can be edited in iRedTouch manually or by tapping the selector which goes from 1 to 5 (reasonable values).
The "1" that follows should not be edited, it is the number of the first timecode pair which is to be repeated.

Hope that helps,

Robert (tin:b Software)

Hosting Services by ipHouse