Post 4 made on Saturday June 18, 2011 at 14:23 |
Lyndel McGee RC Moderator |
Joined: Posts: | August 2001 12,994 |
|
|
I seem to recall 9600, N, 8, 1 and No Flow Control are the preferred settings but I suspect that the software sets those up.
Also, when remote connected to cable, can you hold the cable's plug in the remote such that the plug firmly contacts the side of the jack? If this works, then you may have bad jack or cold solder joint on the board where the jack connects.
|
|
Lyndel McGee Philips Pronto Addict/Beta Tester
|
|