Your Universal Remote Control Center
Custom Installers' Lounge Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 7 made on Saturday March 19, 2011 at 20:32
Select Member
August 2004
On March 19, 2011 at 01:25, fixitnick said...
Thanks Tgrugett,

I'm going to have to give this a try in the morning.

Come to think about it; I haven't had any issues at all with the menu controls. It's only the power on/off like you describe. This just might be the fix.

Without the two part toggle bit code you will only get power toggle depending on the quality of the learn. these are clean and tested so they should work accurately. Just make a macro with the IR codes back to back. I have thought about trying to merge the codes into one string to see if I can get it work but since I always embed my power commands as processor sub routines that application has not been a priority.

Hosting Services by ipHouse